Jump to content
Bottled Ship Builder

Search the Community

Showing results for tags 'health and safety'.



More search options

  • Search By Tags

    Type tags separated by commas.
  • Search By Author

Content Type


Forums

  • Captains Quarters
    • Questions on how to post and use this site / Report problems and offer suggestions
    • New Member?
    • General Ships In Bottles Discussion
    • General Miniature Ship Discussion
    • Build Logs
    • Odds And Ends
  • The Bilge
    • Off Topic
  • The Bottled ShipWright's Topics to Submit

Find results in...

Find results that contain...


Date Created

  • Start

    End


Last Updated

  • Start

    End


Filter by number of...

Joined

  • Start

    End


Group


AIM


MSN


Website URL


ICQ


Yahoo


Jabber


Skype


Location


Interests

Found 1 result

  1. exwafoo

    CA Glue incident

    Hi All, I thought I'd relate the tale of a recent unpleasant incident I had with a bottle of CA Glue (superglue), as a precautionary for all. My preferred method of using this stuff is to put a couple of drops into a beer bottle cap (cheap, disposable and saved for the purpose), and then use whichever applicator is applicable with the drops in the cap. I was unscrewing the cap off of a 20 gm bottle of CA in order to decant the required couple of drops. I was holding the bottle at an angle in my left hand and as the cap came loose from the nozzle it was followed by a jet of glue into my right hand hand, running down the bottle in my left hand, and rapidly spilling off onto my work mat, table, and then on to the floor. My initial reaction (after an expletive or three) was to grab some paper towel I keep handy and start mopping up. It soaked up the glue OK, but I then discovered it was sticking to my hands, and to make matters worse as the towel was compressed it started to get hot - very hot - to the extent of "Ouch! That's beginning to hurt". A quick sprint to the kitchen sink, plunge hands under the cold water and that was that problem sorted, although hands are still covered in CA and paper towel. I used some acetone (nail polish remover stolen from my daughter) to get hands, working mat and table clean, unfortunately the carpet now has a permanent hard spot about an inch in diameter. What caused this? I think this is what happened. The last time I had used the CA the weather was hot and dry - high pressure. A couple of days later we were heading for wind and rain (it is the UK) with the pressure dropping. My workstation was by a window and the little sun we had was shining on the CA bottle, warming it up and increasing the internal pressure. As I released the cap, the internal high pressure took over and out came the contents. I now unscrew the cap slowly and in the vertical position so any pressure differential is sorted out before the CA get anywhere near the nozzle. So, please be careful with glues, solvents etc. Useful things, but they can sneak up and bite you. Best Alan
×