Leaderboard

All, Thanks for your interest, kind comments, questions over the SIB and concern over my hand. I was moving a large patio plant tub by tipping it on edge and rolling it like you do with a barrel and got my hand trapped between it and a wall. Bruised,swollen and stiff for a while. The stiffness lasted, making holding small bits hard, but its just the pinky now, not much use for modeling anyway. I've uploaded some more phots, one with a ruler to show size. I basically measured the inside of the bottle and shrunk the plans to suit, so I haven't actually got a scale. I've started the mainmast, but its only loosely put together to show a general make up, no glue as yet other than the styrene top. A trial cannon on deck - it needs to be a bit higher I made up a couple of jigs a few years ago for making Hinckley Hinges. There is a mast drilling jig in ‘Ship Models in Glass’ that allows accurate drilling. I adapted this so an off centre hole could be drilled. The male and female halves of the hinge are started in this. A line of holes are centre drilled in one piece (female) and then the offset is used to drill a line of holes, then the mast is rotated through 180 degrees and another line of holes is drilled producing the male half. The second jig is a piece of square section brass with a screw to hold the work piece and the end formed at 45 degrees. A 0.5 mm wide saw blade is used to clear out the female half with the jig guiding the cut to 45 degrees. The sides of the male half are trimmed down and the mitres cut. A bit of fettling to get the fit, I then used the sanding jig to reduce the thickness to 1.mm. If anyone wants the full article I wrote on this for Bottleship, PM me and I'll send it on. The cabin windows were cut from styrene sheet. I crosshatched a piece of thin clear sheet from a bit of packaging with a sharp blade, coated it with black dry marker, let it dry and then wiped off, leaving the scores black. Coloured the other side yellow, and glued to the window frames. The wheel is a watch cog. More soon Alan